Basement Wall Framing

Basement framing leads to existence of a new room or a space which can be used as entertainment room for parties or for carrying some official work that needs some extra space. Framing a basement will be tricky endeavor. It is a different challenge as you may have many hindrances to overcome along the whole process of wall framing.

Check the things before basement framing

1. Before basement framing check that area of basement is fully waterproof or not. There should be no water entering form walls and from the floor of basement. There are many companies that that specialize in waterproofing of walls and they visit your home to examine waterproofing with their moisture meter.
2. Basements are load bearing structure so check thoroughly before removing any existing wall. Load bearing basement should have reinforced footing.

Typical structure of the exterior wall

Structure consists of mainly three parts –bottom plate, top plate, a stud, which is part between bottom plate and top plate. Bottom plate rest on the flooring and top plate is adjusted at the bottom of ceiling.

Ways to frame exterior walls

1. Take all the measurement and assemble the structure on the floor, after that lift the well finished structure against the required wall.
2. Screw or nail the bottom plate to the floor and top plate to
3. Ceiling joists and after that fit each stud at bottom plate end and at end of top plate end one by one. This way makes studs straight at first time and easier way to frame the walls of basement.
4. Professional framer uses nails for framing the wall. Framing nailer and finishing nailer are differently used to frame the wall. Finishing nailer had small head and are thin that makes easy to hide them later.
5. Another way is to use screw. First timer framer is advised to use screw as improperly driven screw can be easily removed while framing the wall.

Building your interior partitions

If home is build with clay the basement floor may get slightly up and slightly down according to content of water in the ground. In this case you should use L shaped steel framing clips acted to the first floor- floor joists and to the walls. These chips will allow the walls of basement to move up and down and give support to remain wall vertical. If basement walls had many obstructions such as pipes, duct work then you need to stick build walls around these obstructions.

If drywall has to be build on ceiling then you need to add efficient horizontal wall. Basement Remodeling Bit Sheet can be used in basement remodeling project, it makes the project smooth.